GoldWing Headsets

Attention: open in a new window. PrintE-mail 

Connecting Autocom Headset to an Existing GoldWing intercom.

If choosing to utilise Autocom Headsets with an existing Goldwing Intercom system, there are three (3) components required (depending on which Goldwing you have)

 

 GoldWing headsets

 

 

The standard Autocom Headset (Part 2113) is required, and will fit into most standard Full-Face, Open-Face, or Flip-Front helmets. 

 

 

 Because of the high quality speakers & headsets manufactured by Autocom,  the headsets use a 7-pin DIN plug. 

 It is therefore required to convert the 5-pin Goldwing plugs from 5-pin to 7-pin for the Autocom Headsets.

 

 

 

 

 There are two (2) Goldwing Interface Leads/Adaptors available, depending on which Goldwing you have.

These interface leads are placed under the seat of the bike, and interface between the existing Goldwing headset leads (which run to the outside of the bike), and the internal Goldwing communication system.

The RED power lead coming from the Autocom interface is connected to the Goldwing's AUX power.  This is required to send power to the Autocom headsets.  Please refer to the downloadable Installation Instructions below for further information.

 
 PLEASE NOTE

If only a single Rider is required to connect to a Goldwing system, then only one (1) of each part is required.

If both Rider & Pillion are to be connected to the Goldwing, the two (2) of each components are required.

For Example...

Rider Only:

1 x Headset (Part 2113)

1 x Extension Lead (Part 195)

1 x GL1800 Interface Lead (Part 2054)    

 Rider & Pillion:

2 x Headset (Part 2113)

2 x Extension Lead (Part 195)

2 x GL1800 Interface Lead (Part 2054)

 

 

increase font sizereset font sizedecrease font size

Accessories

Search

Login




Cart

Your Cart is currently empty.

website by DevProducts